M. Barker, T. Burt, K. McCallum-Gaul, Dr M. Barry
The disused Stapylton quarry is located in the suburbs of the Queensland Gold Coast. Gold Coast City Council, as part of the Northern Wastewater Strategy, has included the use of the quarry for storage and re-distribution of reclaimed water from the Beenleigh Water Reclamation Facility (WRF) to the downstream cane farmlands. A comprehensive EIS has been produced, which has strict water quality requirements for the quarry environs as well as the reservoir and outflow. This paper presents the background to the Northern Wastewater Strategy, the requirements for the Stapylton reservoir and the analysis performed for the detailed design of the embankment dam and the inlet bubble plume destratification system. The modelling of the destratification system was undertaken using the programme DYnamic REservoir Simulation Model (DYRESM) coupled with Computational Aquatic Ecosystems DYnamics Model (CAEDYM). The outcomes and implications of the modelling for the design and system operation including environmental monitoring are discussed.
David Ho, Karen Boyes, Shane Donohoo and Brian Cooper
Many dam structures in Australia were designed and built in the 1950s and 60s with limited hydrological information. As a result existing spillway structures are under-sized for today’s revised probable maximum floods (PMF). Potential problems such as the generation of excessive negative pressure over spillway crest under increased flood condition could be encountered. This may cause instability or cavitation damage to the spillway. The raised flow profile may also have adverse impacts on crest bridges and gate structures.
Historically, physical models have been constructed in hydraulic laboratories to study these behaviours, but they are expensive, time-consuming and there are many difficulties associated with scaling effects. Today, with the use of high-performance computers and more efficient computational fluid dynamics (CFD) codes, the behaviour of hydraulic structures can be investigated numerically in reasonable time and expense.
This paper describes the two- and three-dimensional CFD modelling of spillway behaviour under rising flood levels. The results have been validated against published data and good agreement was obtained. The technique has been applied to investigate several spillway structures in Australia.
This paper discusses reliability issues of the fourteen 3.85m high by 7.89m wide radial gates at Glenmaggie Dam in Victoria and the twin 3.6m high by 16.5m wide drum gates at Little Nerang Dam in Queensland. The Glenmaggie dam radial gates are manually controlled using electrically driven (mains and diesel generator power supply) hoist motors with a petrol driven hydraulic pack for use in the event of complete electrical power supply failure. A detailed fault tree analysis was developed for the spillway gate reliability of the Glenmaggie Dam gates as part of the risk assessment for the dam, which was being completed at the time of publishing the paper. Each of the identified components of the spillway gates, including human error in operation was used to evaluate the probability of failure of a single gate or multiple gates for inclusion in the event tree to estimate the risk and assist the evaluation of the requirement for remedial works. The Little Nerang drum gates are fully automatic hydraulically operated gates with independent operating mechanics and a common override system in the event of automatic system failure. Drum gates are uncommon on dams and the system operation is discussed together with an assessment of the reliability and measures taken for handling operating risks during floods for the dam, which has some stability concerns.
Sydney Catchment Authority (SCA) has been progressively enhancing its asset management capability for dams and other headworks infrastructure since 1999. A key to the development of the integrated asset management system has been the application of asset condition assessment and Failure Modes, Effects and Criticality Analysis (FMECA) across the water supply mechanical and electrical assets. This has provided vital data necessary to:
• Identify all the mechanical and electrical assets
• Update the computerised maintenance management system database (MAXIMO)
• Determine asset criticality against a range of factors
• Allow review and rationalisation of maintenance work plans
• Upgrade the System Management Plans
Asset management features as a key result area within the SCA’s Corporate Business Plan. Integrated asset management is achieved by cascading corporate outcomes, strategies, objectives and responsibilities down through divisional and team work plans to individual staff members. This paper covers a range of issues that have a bearing on the day-to-day integrity of the infrastructure required to deliver bulk raw water to the SCA’s customers.
The management of maintenance at Warragamba Dam is used as an example to demonstrate the effectiveness and practicality of the application of the contemporary asset management system.
The paper highlights the fundamental importance of correct data selection and storage for the quality of Asset Management demanded for today’s water industry infrastructure.
In developing this theme, the concept of Risk driven maintenance is introduced to focus attention on those issues that not only the identify the appropriate data to be collected and stored, but also, by way of illustrated examples, the direct relevance and application of reliability engineering principles in Risk Analysis.
The author’s principle objective is to demonstrate that the historical data on reliability, condition and performance must be supported with detailed costing information if any worthwhile outcomes are to be forthcoming from analysis.